Right sorry for the delay, picked it up last week, the canvas is fine except for a little bit of wear where the extension poles rub the roof when being assembled but the flap covers this when assembled, there is one spring loaded button for locking the adjustable laegs missing but these are only pennies & it needs some feet or pads to go under the support poles when its up.
The trailer is sound & has 3 new car tyres on the rims, the only problem I have is the hitch is bolted onto the top of the square box section that is part of the trailer, the hitch lock I have is the Apache hitch lock that wont slide on properly because of this other square tube underneath getting in the way, is there a decent alternative that doesnt break the bank or can I put the hitch back onto the end of the original shaft.
Hope this is clear & I will try tro put a piccie on later.
The cover seems water proof but the colour is fading & it looks like canvas showing in places,can you get a decent cover to go over the lot to help with storing through the winter.
Cheers for any help.
I take it that you have a straight draw bar,not an A frame. If you unbolt the hitch you will get a better idea if it will fit direct,but wont that lift the front of the trailer? A sheet of poly under the cover is a cheap fix until a cheap cover turns up
------------- Silence is golden
Duct tape is silver
I will have to look, theres a board for the gas bottle on at the moment so cant tell, I think it was raised to be towed by a 4x4 so a straight fit will suit my new motor.