Message Forums

If the Pullman is the same set up as the Pathfinder, IE the water heater in front of the axle, then you cannot fit the motor mover there as there is a chassis member across the front of the axle that gets in the way.

The motor mover will have to be fitted behind the axle.

This is not a problem as the control box can be wired for front or rear moving.

You will however require special brackets to allow the motor mover to be fitted to the shallower chassis of an FC as movers are manufactured to fit the much deeper caravan chassis.

I had the Enduro 2 fitted to our Pathfinder and these brackets were another £70.

Yes, some movers require the water drain pipe to be moved as if it is not, water from the drain lands on the motor. On mine it misses the motor by a good half inch.

However, even if it did fall on the motor, I doubt if I would go to all that trouble as the motors are sealed units. They have to be when situated so near the road!!!