Hi
1 - lay inner on ground and peg the two corners of each sleeping area.
2 - slide the colour coded poles through the poles sleeves on the main dome, then the first pole nearest the dome on the sleeping areas then the end poles for the sleeping area.
3 - if you can ask other half to enter the tent and lift the centre of the tent up ( not important how high) then the person on the outside can go around placing the bottom of the poles in the ring and pins which are attatched to the ground sheet.
4 - then repeat for the bedroom poles.
5 - then peg the tent down, not pulling to tight, just so the tent looks neat.
6 - slide the flysheet over the inner and tie onto the frame starting at the higher points.
7 - peg down the flysheet, again if it looks neat youve got it right.
8 - slide the last pole through the pole sleeve on the porch and peg down
9 - guy out tent. Not a hard and fast rule but the guys normally follow the seams on the flysheet.
You can always visit ourselves and we will run through the pitching with you while looking at the show model.
Regards
Gary Cross
cross camping and leisure ltd
Phillimore garden centre, melbourn, nr royston (2nd garden centre of the A10)
|