Message Forums

Hello

Any tried puting two air beds on top of each other to "raise the bed" like a high rise versions as we have 2 Coleman flock covered double inflatables so the flock covering should stop them sliding around, also going to put a fitted sheet around them to keep in position.

Anyone tried this?

Andy

Well not tried it but Intex do something similar so it must work!  Heres the link:

http://www.amazon.co.uk/gp/offer-listing/B000HBO4OU/ref=dp_olp_new?ie=UTF8&qid=1306487374&sr=8-5&condition=new 

Yeah - i am going to give it a go next week. Even if i put some masking tape or gaffer tape around them both to hold in position

Regards

Andy

 Hi Andy,

     We did this last year with no problem at all.

                  Regards Carol

Carol

Did you fix them together in any way or just have one on top of the other?

Regards

Andy

I asked the same question last year

And after taking advice from the king folks on here, we put a cheap Argos air bed on the bottom and the Coleman double on the top. Both had the flock side up -  so it was NOT flock to flock, and we did not fix them. They stayed together just fine, no slipping at all. It was more bouncy than one airbed on its own, but not unpleasantly so ! And I liked being a bit higher off the floor, felt like a real bed. I would recommend it, but do remember that you will be higher inside the bedroom inner so make sure there is room. You could find that if the sides slope inwards steeply, you will have tent inner in your face !!

Ok thanks for that we have the Outwell "high pod" systems so should be enough height - thanks

Andy

 Hi Andy,

     Sorry, only just come back. No we didnt fix them together in anyway. Just had one on top of another and a fitted sheet and they didnt move.

                        Regards Carol

            We put 2 togeather all the time,just tie a strap at top and bottom to keep them togeather.