My Truma Motor Mover II Version 1 works very well but sometimes one side does not, any ideas. Also there is some up and down movement on the unit that holds the motor, is this normal.
I had the same problem and found it to be the spade end that connects the cable to the motor had corroded so I cut the old one off and fitted a new spade end also cleaned the spade on the motor and applied some grease before pulling the rubber cover back over
Quote: Originally posted by rod williams on 19/6/2012
I had the same problem and found it to be the spade end that connects the cable to the motor had corroded so I cut the old one off and fitted a new spade end also cleaned the spade on the motor and applied some grease before pulling the rubber cover back over
yes just same as ours,the mover engineer just pulled back the rubber cover and cleaned the blades.
------------- the only silly question is the one you do not ask.