Struggling to find the securing screws or struggling to lift it out?
You need to be a bit more specific as to how far you have got with the task of removal.
Tango 55 , I've released the 4 securing screws , took the two vent cover off the outside of the van , there's a gas pipe running across one of the vents with a compression fitting on it , not sure whether to undo this as others threads I've read say the gas connection is on top of the fridge once the fridge is pulled out . I'm trying to clean the jet and burner as there's no ignition just the yellow light when on gas setting . I was hoping to be able to get to the jet when I took the bottom vent off but the vent is too high so I think the fridge will have to come out
Do you have the installation booklet? If not you should be able to download one. That may give you more clues on how to remove and where pipe fittings are etc.
You say that other threads have said that the gas pipe is on the top of the fridge so the compression joint may well be a secondary joint merely for installation purposes (access via the vent) which means that the gas inlet port may well be on the top of the fridge with a second connection ie. two gas pipes in line with one connection. I would disconnect the compression joint that you can access via the vent and then see if the fridge then retracts from the compartment but there should also be a lead attached somewhere which is the igniter from the switch to the jet.