Can anyone please help, we have a 2007 swift and our toilet has stopped pumping water. The fuse is intact, but we don't know what else to check, any advise would be appreciated. Thanks in advance.
Pump is likely. Did you empty the flush container last winter and pump out remaining water? Frost will damage the pump. Not an expensive repair though and simple.
Not sure if in time, but before buying a pump consider this.
Remove the waste tank and look in the area where the
Slide plate fits.. next to the slide you will see a micro switch. This to prevent water being flushed if the tank is not in place. This is a good candidate for damage. Well worth a check. Only cost, s 25p from any hardware store.
Following on from bobansens post above is it this fuse you have replaced.
looking at the picture you will see, just behind the blade carrier there are 2 wires, (not the 2 long ones on the left), you can just about see them behind the white block in the center of the picture and the 2 spade connecters at the front, mine broke at the spade connecter.
the constant turning of the blade sometimes makes one of these wires brake off
If this is the case you will have to remove the carrier to rejoin the wire. you will need rubber arms to do this or be a lot younger than me.
The picture is upside down.
Wizzard has a very good guide on how to do this, can any of you ace forum members post it for bob thanks.
[/IMG]
Thanks to all for your advice, problem was solved by replacing the micro switch on the flush system, the plastic sheath which covers the switch had dropped down and left the wiring exposed, so the wires had become damaged through water.
Hope all the advice given my help people with similar issues.