Message Forums

Had a 99 ranger 510/4. I think there should be a switch to turn the pump on and off. I think it's down on the front bed locker.  You need to bleed all the air from the system. Close all the internal taps and make sure the water heater drain is closed with no water pouring out the bottom onto the ground. Put the pump in a full aquaroll and plug it into the side of the van. Switch on the pump switch and open the kitchen hot tap. You should hear the pump runnng but no water coming out the taps. There should be a gurgling and spitting as the air comes out of the kitchen tap. When water flows freely the heater is full of water not air. Then swith on the water heater.

The two lights working in the lounge are most likely 240v lights, perhaps on a pull cord switch from memory so you have not got 12 volts. If that's the case your pump won't work either. Check both circuit breakers are switched on at the panel in the front seat box. You lift to switch on. There is, I think, a switch next to the pump switch which turns on all 12volt systems. Switch this on.

There is a switch on every light.