I have just purchased a second hand Truma M1 motor mover and have just downloaded the instructions for fitting.
According to the instructions the minimum width of the L shaped chassis should be 30mm yet I have measured my L shaped chassis width and it is 28mm.
Does anybody have a Truma M1 motor fitted to a Bailey Ranger 550/6 or know if it is safe to fit on the basis of the chassis L shaped width being 2mm short.
Hi, I have a bailey ranger 500/5 on an alko chassis which I fitted an e-GO mover to. the required width of L shaped needed on that was 30mm to 40mm. I had no problem with my chassis so suspect you will be ok to go ahead and fit your mover to yours. perhaps you mis-measured by a fraction.
Discounted Insurance Quotes for UKCampsite.co.uk visitors! Up to 12.5% off!