Hi
On the outlet side of the pump piping, you will find a brass / copper connector (i think) inside that is wire mesh.
Clean that and you should be fine.
Had that problema a few years ago on our indiana s6.
And that sorted the problem out.
------------- Cheers
Ray
Discovery 4 & Bailey Barcelona 4
Discounted Insurance Quotes for UKCampsite.co.uk visitors! Up to 12.5% off!
not sure. dont think it did.
Its the right hand blue vavle that you need to strip.
you turn the valve in a diffrent direction for on board tank and direct water. been a while since i have done it and can't remember of top of my head.
I stripped pump down and it still did same, and not knowing anything differant bought a new pump.
And no improvement.
So stripped it down and found the mesh. Costly mistake, but on the bright side have a spare pump lol, and still fits the barcelona as well.
Hi back again
Been away in the van and still having problems even after stripping and cleaning the motor
I connected the aquaroll as normal and set to aquaroll to taps but no water appeared
The I set to fill onboard tank from aquaroll and still didn't work, so I pulled the pipe out of the onboard tank filler pipe and sucked on it until the water came through then it will fill tank , if I then switch to van taps it works fine
but if I leave it a few hours it fails again until I suck out the air again
I can see no leaks inside van but if I remove the aquaroll pump whale it drips water which I am sure this didn't happen before
So I'm guessing there is s nonnreturn valve somewhere that is leaking?????
Any ideas
------------- Advice is what we ask for when we already know the answer but wish we didn't.